????
Your IP : 3.12.161.6

Current File : //lib/udev/rules.d/65-md-incremental.rules
# This file causes block devices with Linux RAID (mdadm) signatures to
# automatically cause mdadm to be run.
# See udev(8) for syntax

# Don't process any events if anaconda is running as anaconda brings up
# raid devices manually
ENV{ANACONDA}=="?*", GOTO="md_end"

# Also don't process disks that are slated to be a multipath device
ENV{DM_MULTIPATH_DEVICE_PATH}=="?*", GOTO="md_end"

# We process add events on block devices (since they are ready as soon as
# they are added to the system), but we must process change events as well
# on any dm devices (like LUKS partitions or LVM logical volumes) and on
# md devices because both of these first get added, then get brought live
# and trigger a change event.  The reason we don't process change events
# on bare hard disks is because if you stop all arrays on a disk, then
# run fdisk on the disk to change the partitions, when fdisk exits it
# triggers a change event, and we want to wait until all the fdisks on
# all member disks are done before we do anything.  Unfortunately, we have
# no way of knowing that, so we just have to let those arrays be brought
# up manually after fdisk has been run on all of the disks.

# First, process all add events (md and dm devices will not really do
# anything here, just regular disks, and this also won't get any imsm
# array members either)
SUBSYSTEM=="block", ACTION=="add", ENV{ID_FS_TYPE}=="linux_raid_member", \
	RUN+="/sbin/mdadm -I $env{DEVNAME}"

# Next, check to make sure the BIOS raid stuff wasn't turned off via cmdline
IMPORT{cmdline}="noiswmd"
IMPORT{cmdline}="nodmraid"
ENV{noiswmd}=="?*", GOTO="md_imsm_inc_end"
ENV{nodmraid}=="?*", GOTO="md_imsm_inc_end"
SUBSYSTEM=="block", ACTION=="add", ENV{ID_FS_TYPE}=="isw_raid_member", \
	RUN+="/sbin/mdadm -I $env{DEVNAME}"
LABEL="md_imsm_inc_end"

SUBSYSTEM=="block", ACTION=="remove", ENV{ID_PATH}=="?*", \
	RUN+="/sbin/mdadm -If $name --path $env{ID_PATH}"
SUBSYSTEM=="block", ACTION=="remove", ENV{ID_PATH}!="?*", \
	RUN+="/sbin/mdadm -If $name"

# Next make sure that this isn't a dm device we should skip for some reason
ENV{DM_UDEV_RULES_VSN}!="?*", GOTO="dm_change_end"
ENV{DM_UDEV_DISABLE_OTHER_RULES_FLAG}=="1", GOTO="dm_change_end"
ENV{DM_SUSPENDED}=="1", GOTO="dm_change_end"
KERNEL=="dm-*", SUBSYSTEM=="block", ENV{ID_FS_TYPE}=="linux_raid_member", \
	ACTION=="change", RUN+="/sbin/mdadm -I $env{DEVNAME}"
LABEL="dm_change_end"

# Finally catch any nested md raid arrays.  If we brought up an md raid
# array that's part of another md raid array, it won't be ready to be used
# until the change event that occurs when it becomes live
KERNEL=="md*", SUBSYSTEM=="block", ENV{ID_FS_TYPE}=="linux_raid_member", \
	ACTION=="change", RUN+="/sbin/mdadm -I $env{DEVNAME}"

LABEL="md_end"